from misuse. Lap belts are designed to be worn by
one person at a time.
1. Slowly pull the link end of the lap belt across your
lap. See Fig. 2.12. If it is necessary to lengthen the
belt, tip the link end downward and pull the link until
it connects with the buckle.
2. Fasten the lap belt by pushing the link into the
buckle until they latch. Make sure the belt is not
twisted. Check the engagement by trying to pull the
link out of the buckle. If they come apart, repeat
this step. If the problem continues, replace the belt.
NOTE: The belt can be shortened after it is con-
nected by pulling on the loose end until the belt is
snug, but comfortable.
3. To release the belt, push the release button on the
buckle and pull the link from the buckle.
01/18/95
f910049a
Fig. 2.11, Releasing the Three-Point Seat Belt (typical)
1
2
3
A
01/06/95
f910068a
A. Pull on loose end to shorten belt.
1. Buckle
2. Belt Release Button
3. Link
Fig. 2.12, Lap Belt Adjustment
Vehicle Access and Features
2.10
To Next Page
Loading...
