Common Warning and Indicator Lamps
Lamp Description Color
Diesel Particulate Filter
(DPF) Status
Solid illumination indicates a regen is required. Change to a
more challenging duty cycle (such as highway driving ) to
raise exhaust temperatures for at least twenty minutes, or
perform a parked regen.
Blinking indicates that a parked regen is required
immediately. An engine derate and shutdown will occur.
Amber
Malfunction Indicator
Lamp (MIL)
Indicates an emissions-related fault. See the engine
operation manual for details.
Vehicle ABS
Momentary illumination indicates the vehicle ABS is
engaged.
Solid illumination indicates a problem with the vehicle ABS.
Repair the ABS immediately to ensure full braking
capability.
Trailer ABS
Momentary illumination indicates the trailer ABS is engaged.
Solid illumination indicates a problem with the trailer ABS.
Repair the ABS immediately to ensure full braking
capability.
NO
CHARGE
No Charge
Indicates the alternator is not properly powering the
electrical system.
Water in Fuel
Indicates the fuel may contain water. Drain any water
collected in the fuel/water separators.
Fuel Filter Restriction Indicates the fuel filter is clogged and requires service.
Check Transmission Indicates an undesirable transmission condition.
Transmission Overheat Indicates high transmission temperature.
WHEEL
SPIN
Wheel Spin
Flashing indicates the ATC system is active, or the ATC
button has been pressed to allow wheel slip.
Solid illumination indicates a problem with the ATC system.
Repair the ATC system immediately to ensure full braking
capability.
Engine Brake Indicates the engine brake is enabled.
Green
Left-Turn Signal
Flashing indicates the outside left-turn signal lights are
activated.
Instruments
4.5
To Next Page
Loading...
Need help?
General
