In addition to seat belt assemblies, tether belts are
installed on suspension-type seats. Tether belts help
secure the seat to the floor and are intended to re-
strain the seat and seat belt in case of an accident or
sudden stop.
IMPORTANT: Seat belts have a finite life which
may be much shorter than the life of the vehicle.
Regular inspections and replacement as needed
are the only assurance of adequate seat belt
security over the life of the vehicle.
Seat Belt Inspection
WARNING
Inspect and maintain seat belts. When any part of
a seat belt system needs replacement, the entire
seat belt must be replaced, both retractor and
buckle side. Any time a vehicle is involved in an
accident, and the seat belt system was in use,
the entire vehicle seat belt system must be re-
placed before operating the vehicle. Do not at-
tempt to modify the seat belt system; doing so
could change the effectiveness of the system.
Failure to replace worn or damaged seat belts, or
making any modifications to the system, may re-
sult in personal injury or death.
Inspect the seat belts and tether belts (if so
equipped).
1.
Check the web for fraying, cuts, extreme dirt and
dust, or for severe fading from exposure to sun-
light, especially near the buckle latch plate and in
the D-loop guide area.
2.
Check operation of the buckle, latch, Komfort
Latch or Sliding Komfort Latch (if equipped), web
retractor, and upper seat belt mount on the door
pillar. Check all visible components for wear or
damage.
3.
Check the seat belt and tether belt connection
points and tighten any that are loose.
Seat Belt Operation
Three-Point Seat Belt With Komfort Latch
NOTE: For vehicles not equipped with the Kom-
fort Latch, see the seat belt operation under the
heading "Three-Point Seat Belt."
WARNING
Wear three-point seat belts only as described
below. Three-point seat belts are designed to be
worn by one person at a time. In case of an acci-
dent or sudden stop, personal injury or death
could result from misuse.
Fasten the seat belts before driving. Fastening a
three-point seat belt while driving creates a haz-
ard.
1.
Slowly pull the link end of the three-point seat
belt out of the retractor and pull it across your
lap (from outboard to inboard) far enough to en-
gage the buckle. If the retractor locks too soon,
allow the belt to retract slightly, then slowly pull it
out again.
2.
Fasten the three-point seat belt by pushing the
link into the buckle until it latches (
Fig. 7.7). Give
the belt a tug at the buckle. If the buckle un-
latches, repeat this step. If the problem contin-
ues, replace the three-point seat belt.
3.
Position the shoulder strap diagonally across
your chest with the adjustable D-loop bracket (if
equipped). The shoulder strap must be centered
on your shoulder and chest, away from your face
and neck. See
Fig. 7.8. If desired, engage the
Komfort Latch as follows.
Pull on the shoulder strap to lessen the pressure
of the strap on your shoulder and chest. Allow no
01/18/95
f910004a
Fig. 7.7, Fastening the Three-Point Belt
Seats and Restraints
7.7
To Next Page
Loading...
Need help?
General
