EasyManua.ls Logo

freightliner Run Smart ARGOSY - Ignition Switch and Key

freightliner Run Smart ARGOSY
166 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ignition Switch and Key
The ignition switch has four positions: OFF, ACC (ac-
cessory), ON, and START. See
Fig. 5.1. The ignition
key also locks and unlocks the cab doors, baggage
door(s), and if equipped, the bunk door(s).
In the OFF position, the ignition switch is vertical.
The key can be inserted and removed only in the
OFF position.
The following functions are operable when the igni-
tion switch is in the OFF position (regardless of
whether the key is inserted):
low-beam headlights
taillights
brake lights
road lights
dome lights
clearance lights
hazard warning lights
turn signals
utility lights
baggage compartment lights
spotlights
electric horn
clock
refrigerator
CB radio
power mirrors
power receptacle
fuel heater
electric oil pan heater
electric or diesel-fired engine coolant pre-
heater
Turn the key counterclockwise to reach the ACC po-
sition. In addition to all the functions that are oper-
able in the OFF position, the following functions are
operable when the switch is in the ACC position:
radio/stereo system
heater and A/C fan
mirror defog
windshield fan
ether start system
air dryer
backup lights
Turn the key clockwise past the OFF position to
reach the ON position. When the ignition is turned
on, the following actions should occur:
electronic gauges complete a full sweep of
their dials
warning and indicator lamps illuminate, then
are extinguished
audible alert sounds for approximately four
seconds or until sufficient air pressure builds
up in the primary and secondary air systems
software revision level of the ICU is displayed
on the driver message center, followed by any
active faults
IMPORTANT: If any red or amber warning or
indicator lamps do not illuminate during the ICU
self-check or do not extinguish after the self-
check completes, take the vehicle to an autho-
rized Daimler Trucks service facility as soon as
possible.
IMPORTANT: Do not crank the engine until the
ICU gauge sweep is complete.
07/19/2006 f610805
Fig. 5.1, Ignition Switch
Driver Controls
5.1

Table of Contents

Related product manuals