the engine while it is in derate mode could cause
severe damage to the engine.
Power Takeoff (PTO) Governor
Engine power takeoffs (PTO) tap into engine power
to run auxiliary devices, such as hydraulic pumps
that power additional equipment. The following are
general guidelines for operating a PTO.
1.
Set the parking brake and put the transmission in
neutral.
2.
Press the dash PTO switch. Release the switch
when the light begins to blink.
When the light illuminates steadily, the PTO is
engaged and ready to operate. In stationary
mode, the vehicle must remain in neutral with the
parking brake set.
3.
To activate mobile mode, shift from neutral to
reverse, 1st, or 2nd gear. The clutch will open
and the PTO will disengage for a moment.
4.
Touch the accelerator pedal to close the clutch
and engage the PTO in mobile mode. The PTO
may be operated with the transmission in neutral
or reverse, and 1st and 2nd gears only.
NOTE: Do not attempt to change gears while
the vehicle is moving. The transmission will ig-
nore the request.
5.
To deactivate mobile mode, bring the vehicle to a
stop. The clutch will open and shut down power
to the PTO.
6.
To resume stationary mode, shift to neutral. The
PTO will engage.
7.
To deactivate PTO, press the PTO switch again.
When the light in the switch goes out, power to
the PTO is shut off.
Optional Engine Systems
10.2
To Next Page
Loading...
Need help?
General
