Friedrich VRP24K - Electrical Connection

26
Electrical Installation
Remove and discard hole knock-out from the side
of the unit (Detail A)
Remove the Electrical Access Panel (Detail B) to
expose the Incoming Power Terminal Block
(Detail C, see below)
B
Ground L1 L2
Insert all wires (Green, Black, Red) through the
punched out hole and fasten wires as follows:
Green to Ground
Black to L1
Red to L2
Electrical Installation
Electrical Installation
Remove and discard hole knock-out from the side
of the unit (Detail A)
Remove the Electrical Access Panel (Detail B) to
expose the Incoming Power Terminal Block
(Detail C, see below)
B
Ground L1 L2
Insert all wires (Green, Black, Red) through the
punched out hole and fasten wires as follows:
Green to Ground
Black to L1
Red to L2
Electrical Installation
Remove and discard hole knock-out from the side
of the unit (Detail A)
Remove the Electrical Access Panel (Detail B) to
expose the Incoming Power Terminal Block
(Detail C, see below)
B
Ground L1 L2
Insert all wires (Green, Black, Red) through the
punched out hole and fasten wires as follows:
Green to Ground
Black to L1
Red to L2
Remove and discard hole knock-out from
the side of the unit (Detail A)
Remove the electrical access panel (Detail B) to expose the
incoming Ppwer terminal block (Detail C, see below)
Insert all wires through the
punched out hole and fasten
wires as follows:
Ground
L1 L2