60
2. Check that the lint filter is
clean and in place
3. Load the dryer and close the
door
a. Load items loosely. The average wet load will fill the
drum with 1/3 to 1/2 full. The items need room to tumble
freely for drying and to cause less wrinkling.
b. If required, place a dryer fabric softener sheet on top of
the load at the beginning of the cycle.
c. Do not overload the dryer to save energy and time and
avoid uneven drying and wrinkling.
d. Dry only two or three items at a time when drying large
items. Fill up the load with small and medium sized items.
e. Add two or three similar items to improve the tumbling
action for delicate or very small loads.
4. Select the appropriate cycle
and settings for each load
• See the section Dryer Operating Instructions, for more
information.
5. Start the Dryer
a. Close the dryer door. The dryer will not operate with
the door open.
b. Push in or turn the cycle selector knob or turn any
option knob to “wake” the dryer. You will hear three beeps to
indicate that the dryer is ready to operate.
c. After making your selections, push in the selector knob
to start the cycle. You will hear one beep before the drum
begins to rotate.
d. To add or remove items when the dryer is running, push
in the cycle selector knob to pause the cycle and open the
door. Opening the dryer door during a running cycle will also
pause the cycle. You will hear two beeps. Allow the drum to
stop completely before reaching inside. Add or remove the
CAUTION
Do not operate dryer without the lint filter in
place.
NOTE
Over-drying can cause wrinkles, shrinkage, lint,
harshness and build up a static electricity.
To Next Page
Loading...
Need help?
General
