SANITIZING FIXED PARTS
While the removable parts soak in the sanitizer
inside the tub, proceed sanitizing the fixed parts of
the machine:
SANITISING THE CYLINDER
• Immerse a disposable paper cloth in the
sanitising liquid.
• Pass the cloth over all the batch freezing
cylinder surfaces.
• Also pass the cloth over the visible internal and
external surfaces of the drain pipe.
• Use the brush, previously immersed in the
sanitizing solution, to clean the drain pipe
thoroughly.
• Pass the cloth over the outer edge of the
cylinder until reaching the surfaces of the upper
cover and front panel.
SANITIZING DRIVE SHAFT
• Immerse a disposable paper cloth in the
sanitizing liquid.
• Pass a cloth over the entire surface of the drive
shaft positioned at the centre of the batch
freezing cylinder. Pay particular attention to the
drive gauge and the joint on the bottom with the
base of the batch freezing cylinder.
- Never use any type of solvents and/or thinners to preserve the plastic parts and
gaskets during washing.
- Chemical sanitizing products must be used in compliance with standards in force and
with the utmost caution.
- During sanitizing operations, do not touch parts with tissues, sponges, rags or any
other material.
To Next Page
Loading...
