Fritz! Fon M2 - Settings in the FRITZ!Box User Interface

FRITZ!Fon 58
Settings in the FRITZ!Box User Interface
FRITZ!Fon M2 58
• Reset: the “Reset” command restores FRITZ!Fon M2 to its fac-
tory settings. All settings you made for this device will be dis-
carded.
13.2 Settings in the FRITZ!Box User Interface
FRITZ!Fon M2 offers the greatest convenience if you use a FRITZ!Box
that supports DECT as the base station. This section describes func-
tions and settings you can configure for FRITZ!Fon M2 in the
FRITZ!Box user interface.
1. Open the user interface of the FRITZ!Box in a web browser
(http://fritz.box
).
2. Select “Telephony / Telephony Devices” in the user interface.
3. Click the “Edit” button to open the settings of your FRITZ!Fon M2.
4. Configure the desired settings. Then click the “OK” button to
save your settings.
You can configure the following settings:
All current functions and settings are at your disposal if
both devices are using the current firmware. For more in-
formation, see the Updating the Firmware from page 61
section.
For more information on these settings, see the Help on
the user interface.
Handbuch_FRITZ!Fon M2-en.fm Seite 58 Mittwoch, 10. Oktober 2012 1:39 13