6
4. Installation of the device
4.1 DELIVERY AND UNPACKING
Use a pallet truck to move the freezer on its pallet. It is imperative to keep the freezer unpacked to avoid any risk of
tipping over. The device can be placed on the ground and maneuvered thanks to the wheels. After positioning the device
in the desired location, remove the various protective plastics and shims.
Do not forget to remove the foam padding shelves (at the bottom thereof) to avoid damaging the gates when closing
the door once the freezer is at -80 ° C.
Froilabo freezers are delivered on a pallet equipped with an unloading ramp. In fact, they do not require specific
equipment to get off the pallet. Please refer to the handling and unpacking sheet attached to the device.
After the reception, please check the contents of the delivery.
Do not use sharp objects to avoid damaging the paint. Do not tip the device. Preserve the device as much as
possible from all vibrations. Two people are needed to move the device.
Protective gloves should always be worn!
4.2 SETTING UP AND INSTALLATION
The freezer is designed for use under the following environmental conditions (according to EN 61010-1):
• Indoor use only
• Maximum altitude: 2000 m
• Ambient temperature range between 18 ° C and 32 ° C
• Maximum relative humidity of 80% for temperatures up to 22 ° C
• Supply voltage ripple < ±10 % of rated voltage
• Supply network voltage surges: category II (Standard IEC 60364-4-44)
• Maximum level of room pollution: 2
1 detachable power cord L=2.50m with IEC19 connector
1 pressure relief valve + 1 x foam valves
To Next Page
Loading...
