9
After stopping the freezer completely, remove the valve foam to dry. Before restarting the freezer, replace the dry foam.
After CO2 or LN2 injection, it is necessary to dismantle the decompression valve and reposition the inner circular silicone
membrane properly in order to ensure the correct sealing inside of the valve.
Heating door seal:
Froilabo freezers are equipped with a heating door seal to prevent the formation of ice and thus maintain an optimal
seal of the freezer.
Refer to the "Maintenance, cleaning and decontamination" section for cleaning the door seal.
Air filter:
In order to maintain the cooling performance of the device and to preserve the compressors lifespan, an air filter is
placed in front of the condenser.
It is necessary to dust or wash this filter as frequently as necessary.
A device must never operate without a filter.
Clamping handle:
The device has a progressive tightening handle. Its double action makes it easier to open and close the door. The freezer
door can be locked thanks to the key lock located on the side of the handle.
4.6 TECHNICAL CHARACTERISTICES AND REFRIGERATION SYSTEM
Technical characteristics:
FREEZER MODEL BM340 BM515 BM690
-86 -45 -86 -45 -86 -45
GENERALITIES
Gross volume (litres) 340 340 515 515 690 690
Number of compartments 2 2 3 3 4 4
Freezer mass (kg) 223 178 267 222 330 285
Maximum power consumption
230V (Watts) (BoSS System)
1500 1500 2150 1500 2150 1500
Power consumption* 230V, 50
Hz (Watts)
900 1000 1150 1000 1150 1000
To Next Page
Loading...
