3 Heating up for the first time
CAUTION
If the boiler heats up too quickly on initial start-up:
If the output during the heating-up process is too great, the combustion chamber may
be damaged as a result of drying out too rapidly!
For this reason the following applies the first time you heat up the boiler:
❒ Start the firewood boiler for the first time in accordance with the heating instruc‐
tions
Heating instructions when starting up a firewood boiler for the first time
❒ Place a piece of wood diagonally across the combustion chamber (see diagram on
left)
➥ Load the boiler with a small amount of firewood (max. 10-20% of the fuel load‐
ing chamber)
➥ Ignite it and allow it to burn slowly with the central pre-heating chamber door
open
NOTICE! Fissures are normal and do not indicate a fault
Once the material in the boiler has burnt down, the boiler can be used in accordance
with the operating instructions ("Operating the system" section).
Heating up for the first time
3
Assembly Instructions Combustion chamber for FHG/S3 Turbo | M1410012_en-us 11
To Previous Page
Loading...
Need help?
General