Fronius SnapINverter
General IMPORTANT! Settings under the "Meter" menu item are only to be made by trained and
qualified personnel!
The service password must be entered in order to access the "Meter" menu item.
Three-phase or single-phase Fronius Smart Meters can be used. In both cases, the
selection is made under the "Fronius Smart Meter" item. The Fronius Datamanager auto-
matically identifies the meter type.
A primary meter and several secondary meters can be selected. The primary meter
needs to be configured first before a secondary meter can be selected.
Connecting to the
Fronius Dataman-
ager
Access point:
1
Select the "Setup" menu on the inverter display and enable the "Wi-Fi Access Point".
2
Establish the connection to the inverter in the network settings (the inverter is dis-
played with the name "Fronius_240.XXXXXX").
3
Password: Enter 12345678 and confirm.
4
In the browser address bar, enter and confirm the IP address http://192.168.250.181
and confirm.
The Fronius Datamanager start page is displayed.
LAN:
1
Connect the Fronius Datamanager and computer to a LAN cable.
2
Place the Fronius Datamanager IP switch in the 'A' position.
3
In the browser address bar, enter and confirm the IP address http://169.254.0.180
and confirm.
Configuring the
Fronius Smart
Meter as the
primary meter
1
Go to the Fronius Datamanager website.
- Open the web browser.
- In the address bar of the browser, enter the IP address (IP address for WLAN:
192.168.250.181, IP address for LAN: 169.254.0.180) or the host and domain
name of the Fronius Datamanager and confirm.
- The Fronius Datamanager website will be displayed.
2
Click the "Settings" button.
3
Log in to the login area with the "service" user and the service password.
4
Call up the "Meter" menu area.
5
Select the primary meter from the drop-down list.
6
Click the "Settings" button.
7
In the pop-up window, set the position of the meter (feed-in point or consumption
point). For more information on the position of the Fronius Smart Meter, see Posi-
tioning on page 6.
8
Click the "Ok" button when the OK status is displayed. If the Timeout status is dis-
played, try again.
9
Click the button to save the settings.
21
EN
To Next Page
Loading...
Need help?
General
