60
The housing must never be opened by anyone other than a Fronius-trained service engi-
neer. The device must be disconnected from the mains before starting any work with the
housing open. A suitable measuring instrument must be used to ensure that electrically
charged components (e.g. capacitors) are fully discharged. Ensure that the device remains
disconnected from the mains until all work has been completed.
This warning sign is located inside the de-
vice. It must NOT be removed or painted
over.
The discharge time of the capacitors is ap-
prox. one minute.
Proper use The charger is designed to charge the power sources listed below. Any use above and be-
yond this purpose is deemed improper. The manufacturer shall not be liable for any dam-
age resulting from such improper use. Proper use also includes:
- carefully reading these operating instructions
- following all the instructions and safety rules in these operating instructions
WARNING!
Charging any other devices can cause serious injury or damage, and is therefore
prohibited.
The following power sources may be charged:
- Fronius AccuPocket 150/400
- Fronius AccuPocket 150/400 TIG
The charger is intended solely for commercial use.
Entladezeit > 5 sek.
Discharge time > 5 sec.
Temps de décharge > 5 s
To Next Page
Loading...
