Fronius MagicWave 3000 User Manual

Cold wire setup
General The cold wire setup is only available if a cold wire feeder is connected to the power
source.
Opening the AC
setup
1
Press the Mode button to select 2-step mode or 4-step mode
The image for the TIG welding parameter is shown on the display:
TIG welding parameters for 2-step mode
TIG welding parameters for 4-step mode
2
Press Menu key
The main menu appears:
3
Use the adjusting dial to select "cold wire setup" (turn the adjusting dial)
121
EN

Fronius MagicWave 3000 Specifications

General

Brand	Fronius
Model	MagicWave 3000
Category	Portable Generator
Language	English