Wire wdraw
Unit mm in.
Setting range OFF / 1 - 50 OFF / 0.04 - 1.97
Factory setting OFF OFF
IMPORTANT!Wire withdrawal prevents the welding wire from burning at the end.
Before the welding current is switched off, the wire is withdrawn to the set value. A pre-
requisite for this function is that the arc has ignited.
Push-pull
Selecting and calibrating the push-pull unit
Unit -
Setting range 00 - KD7000/VR1530KD22m
01 - KD7000/VR1530KD30m
02 - RobactaKD-Drive 10m
03 - RobactaKD-Drive 220m
15 - KD7000/VR1530KD10m
18 - RobactaKD-Drive 5m
19 - KD4010 10m
21 - BinzelTorchDr.IWG 8m
25 - KD7000-VR1530KD10m
Factory setting 0
125
EN
To Next Page
Loading...
