Fronius Primo 8.2-1 - Close the Housing

118
IMPORTANT! The included angle must not
exceed 11°.
In the connection area pull the inverter
forwards from the wall bracket, then lift
the inverter and remove it from above.
Opening the housing
Loosen 4 x 5x18 mm TX25 screws (5)
and the sealing washer until the power
module cover (6) can be removed.
Close the hous-
ing
Close the housing
Make sure the 15 x EMC springs (1)
are correctly positioned.
4.33 in.
110 mm
max. 11°
5
(5) (5) (5)(5)(6)
6
(1)
1