Fronius Robacta PTW 3500 - Assembling the Robacta PTW 3500 (continued)

0
1
... and adjust tungsten electrode
3
1
4
1
5
2
3
1
6
Calibrating the
PTW 1500 adjus-
ting gauge
2
1
Setting the adjusting gauge to measurement „x“
IMPORTANT! The standard setting for
measurement „x“ on the adjusting gau-
ge depends on the diameter of the
plasma nozzle. Refer to the following
table when adjusting the standard set-
ting for measurement „x“:
∅ Plasma-
nozzle
„x“ Adjusting
gauge
1.0 mm - -
1.5 mm 1.5 mm ∅1.5 - 2 mm
2.0 mm 2.0 mm ∅1.5 - 2 mm
2.5 mm 2.5 mm ∅2.5 - 3 mm
3.0 mm 2.5 mm ∅2.5 - 3 mm
32