7
NOTE!
Always screw the Teach-gauge tightly
up to the torch body.
8
NOTE!
The diagram opposite shows the end
position with Teach-gauge.
Use this position as the starting point
for the program sequence when clean-
ing the welding torch.
NOTE!
Ensure that the torch body including
the Teach-gauge is positioned cor-
rectly on the cleaning head - observe
the following information for this pur-
pose.
9
NOTE!
Ensure that the Teach-gauge is posi-
tioned on the cleaning head with no air
gap.
37
EN-US
To Next Page
Loading...