Fronius Robacta Reamer Braze+ - Defining the Welding Torch Cleaning Position; Welding Torch Cleaning Position

Defining the Welding Torch Cleaning Position
Welding torch
cleaning position
Adjust the welding torch cleaning position as shown below:
1
1
2
Set the "Calibrate cleaning head" input signal for one second
-
this will move the cleaning head to the correct starting position
3
Deactivate the "Calibrate cleaning head" input signal
4 5
6
NOTE!
Before the set-up process, place the
Teach-gauge on the cleaning head,
and ensure that the cleaning device
has been set up to be straight from a
horizontal and vertical perspective.
If this is not the case, correct the as-
sembly position.
36