Fronius Robacta Reamer Braze+ - Page 54

72 pages

To Next Page

To Previous Page

(1)

NOTE!

Hearing the locking bolt (1) clicking

into place tells you that the motor

cover is now closed.

Main Page

Table of Contents3
Safety Instructions5
Explanation of Safety Instructions5
General5
Intended Use6
Environmental Conditions6
Obligations of the Operating Company6
Obligations of Personnel6
Particular Hazard Areas6
Personal Protection and Protection of Others7
EMC Device Classifications7
EMC Measures8
EMF Measures8
Safety Measures at the Setup Location and During Transport8
Safety Measures in Normal Operation9
Maintenance and Repair9
Safety Inspection9
Disposal9
Safety Symbols10
Copyright10
General11
Warning Notices Affixed to the Device13
Warning Notices on the Cleaning Device13
Transport15
Transport Equipment15
Transport Instructions on the Packaging15
Information about Unpacking the Device15
Scope of Supply17
Available Options17
Operating Controls, Connections and Mechanical Components19
Safety21
Operating Controls, Connections and Mechanical Components22
Harting Han6P (X1) Connecting Plug Configuration for the Robot Control23
General23
Harting Han6P (X1) Connecting Plug Configuration23
Installation and Startup25
Safety27
Before Installation28
Intended Use28
Operating Personnel, Maintenance Personnel28
Setup Regulations28
Specifications for the Compressed Air Supply28
Measures to Ensure Safe Operation of the Device When Operating Personnel Are Untrained29
Permitted Cable Length29
Screwing the Cleaning Device to the Solid Surface30
Screwing the Cleaning Device to the Surface30
Installation of Optional Wire Cutter31
Assignment of the Connecting Plug31
Installing the Wire Cutter31
Setting up the Compressed Air Supply33
Setting up the Cleaning Device Compressed Air Supply, Compressed Air Relief Valve Function33
Cleaning the Cleaning Head34
Installing the Cleaning Head34
Defining the Welding Torch Cleaning Position36
Welding Torch Cleaning Position36
Start up the Cleaning Device40
Requirements for Starting up40
Start-Up Operation40
Cleaning Program Sequence41
Safety41
Cleaning Program Sequence42
Signal Sequences45
Service, Maintenance and Disposal47
Safety49
Service, Maintenance and Disposal50
General50
Before Every Start-Up50
Weekly50
Every 6 Months50
Whenever Required50
Changing the Cleaning Blades50
Changing the Cleaning Brushes55
Disposal58
Troubleshooting59
Safety61
Troubleshooting62
Errors in the Program Sequence62
Technical Data63
Technical Data65
Robacta Reamer Braze65
Appendix67
Declaration of Conformity69

Fronius Robacta Reamer Braze+ - Page 54

Table of Contents

Related product manuals