(c) Fronius International GmbH, 2020
10/19
Step 9
Leave this window open until
the State changes to OK or
Timeout
Step 10
If State is OK then set meter
location. Refer to Section 1.1
of this guide for explanation of
Step 11
Select Ok to go back to the
Step 12
Select the tick to save the
Older software versions do not
have the List of Configured
Meters or Secondary Meter
If the State is Timeout then retry
the process. If it still times out
refer to troubleshooting steps at
the end of this guide
To Next Page
Loading...
