8
Qualified service
engineers
Noise emission
values
EMC measures
Disposal
Data protection
The servicing information contained in these Operating Instructions is intend-
ed only for the use of qualified service engineers. An electric shock can be fa-
tal. Do not perform any actions other than those described in the
documentation. This applies even if you are qualified to do so.
All cables and leads must be secured, undamaged, insulated and adequately
dimensioned. Loose connections, scorched, damaged or inadequately dimen-
sioned cables and leads must be immediately repaired by authorised person-
nel.
Maintenance and repair work must only be carried out by authorised person-
nel.
It is impossible to guarantee that bought-in parts are designed and manufac-
tured to meet the demands made of them, or that they satisfy safety require-
ments. Use only original spare parts (also applies to standard parts).
Do not carry out any modifications, alterations, etc. to the device without the
manufacturer's consent.
Components that are not in perfect condition must be replaced immediately.
The maximum sound power level of the inverter is specified in the Technical
Data.
The device is cooled as quietly as possible with the aid of an electronic tem-
perature control system; this depends on the amount of converted power, the
ambient temperature, the level of soiling of the device, etc.
It is not possible to provide a workplace-related emission value for this device
because the actual sound pressure level is heavily influenced by the installa-
tion situation, the power quality, the surrounding walls and the properties of
the room in general.
In certain cases, even though a device complies with the standard limit values
for emissions, it may affect the application area for which it was designed (e.g.
when there is sensitive equipment at the same location, or if the site where the
device is installed is close to either radio or television receivers). If this is the
case, then the operator is obliged to take appropriate action to rectify the situ-
ation.
To comply with the European Directive 2002/96/EC on Waste Electrical and
Electronic Equipment and its implementation as national law, electrical equip-
ment that has reached the end of its life must be collected separately and re-
turned to an approved recycling facility. Any device that you no longer require
must either be returned to your dealer or given to one of the approved collec-
tion and recycling facilities in your area. Ignoring this European Directive may
have potentially adverse affects on the environment and your health!
The user is responsible for the safekeeping of any changes made to the fac-
tory settings. The manufacturer accepts no liability for any deleted personal
settings.
To Next Page
Loading...
Need help?
General
