12
3
Note! When mounting the mounting bra-
cket on the wall, ensure that the mounting
bracket does not become warped or defor-
med.
Fitting the mount-
ing bracket to a
mast or support
When installing the inverter on a mast or
support, Fronius recommends the "Pole
Clamp" kit from Rittal GmbH (order no. SZ
2584.000).
This kit enables the inverter to be installed
on round or rectangular masts with the fol-
lowing diameters: from 40 to 190 mm
(round mast), from 50 to 150 mm (rectan-
gular mast)
Fitting the mount-
ing bracket to
metal supports
The mounting bracket must be securely screwed to at least four points.
1
3
1
To Next Page
Loading...
