Entering/exiting the Setup menu
Process parameters
Start/End
I-S Starting current (135)
AlS Start arc length correction (0)
t-S Starting current time (o)
SL1 Slope 1 (1.0)
SL2 Slope 2 (1.0)
I-E Final current (50)
AlE End arc length correction (0.0)
t-E Final current time (o)
SFI SFI ignition (o)
SFI-HS SFI HotStart (o)
W-r Wire retract (0.0)
IgC Ignition current (manual), (450)
W-r (man.) Wire retract (manual), (0.0)
Gas Setup
Gpr Gas pre-ow (0.1)
GPo Gas post-ow (0.5)
Process control
PSt Penetration stabilizer (0.0)
AISt Arc length stabilizer (0.0)
Components
C-C Cooling unit operating mode (auto)
C-t Filter time ow sensor (10)
Fdi Feeder inching speed (10.0)
ito Ignition timeout (o)
STICK
I-S Starting current (150)
Hti Starting current time (0.5)
Eln Characteristic (I-constant)
Ast Anti-stick (on)
Uco Break voltage (90.0)
TIG
Uco Break voltage (14.0)
CSS Comfort-Stop sensitivity (0.8)
SynchroPulse
Syn-Puls SynchroPulse (o)
vd Wire speed (5.0)
dFd Delta wire feed (2.0)
F Frequency (3.0)
DC Duty cycle (50)
Al-h Arc correction high (0.0)
Al-l Arc correction low (0.0)
Process Mix
vd Wire speed (1.5)
AlC Arc length correction (0.0)
PDc Pulse/dynamic correction (0.0)
Hptc Upper power time correction (0)
Lptc Lower power time correction (0.0)
Lpc Lower power correction (0.0)
R/L-check / alignment
Aligning welding circuit resistance
welding circuit inductivity
Settings
Display
Einh. Units
Norm Standards
UIBS Display brightness setting
F1/F2 Param.
User-dened parameters for F1
and F2
Favorit Favourite key
IP System data
System
CLS Housing lighting setup
FAC Restore factory settings
Web-PW reset Reset website password
Information: IM-V. / SWV / IP
Operating mode setup: S4T / iJob
Language
cs, de, en, etc.
Activating/deactivating the key lock
Text display
Abbreviation Full text
Favourite
The Favourite key can be assigned the Setup parameter or Setup
folder that is currently selected.
Retrieve:
To Previous Page
Loading...
Need help?
General
