Fronius TransPocket 1500 - Removing Remote Control Socket Seal (Cont.); Removing Potentiometer and Remote Control Socket; Fitting Potentiometer and Remote Control Socket

103
Removing the
seal for the
remote-control
unit connection
socket
- Carefully pull the seal (7) for the
remote-control unit connection socket
out of the front of the housing
Note! Never use force to detach the potentiometer (29) and the remote-control
unit connection socket (30) from the LCA 15 board. Before any work involving
the soldering iron, always clean the tip of the soldering iron.
- Solder on 5 soldering points (90) for the potentiometer
- Completely remove the solder from the soldering points (90), using a solder
absorption strand or suction pump
- Carefully detach the potentiometer (29) from the FPA 15 board
- Solder on 4 soldering points (91) for the remote-control unit connection socket
- Completely remove the solder from the soldering points (91), using a solder
absorption strand or suction pump
- Carefully detach the remote-control unit connection socket (30) from the FPA 15
board
Fitting the
potentiometer
and remote-
control unit
connection
socket
Note! Only use special electronics soldering tin for soldering-on the
potentiometer (29) and the remote-control unit connection socket (30)
- Carefully insert the potentiometer (29) into the 5 soldering points (90)
- Solder the potentiometer (29) onto the 5 soldering points (90)
- Insert the remote-control unit connection socket (30) into the 4 soldering points (91)
- Solder the remote-control unit connection socket (30) onto the 4 soldering points (91)
Removing the
potentiometer
and remote-
control unit
connection
socket
Fig.10
(7)
(90) (91) (30) (29)
Fig.11 Fig.12