Fronius TransPocket 1500 - Fitting FPA15 Board with Seal and Sockets

112
- Fasten the X3 cable (blue) (72) and
the by-pass capacitors (73) onto the
copper bracket (55), using the 5x12 -
TX20 screw (68)
- Tighten the 5x12 - TX20 screw (68)
with a torque of 2 Nm
Fitting the FPA15
board
- Swing the copper bracket (55) back
into its original position
- Carefully press the FPA15 board until
all the alignment pins have snapped
into place
- TP 1500 TIG: Tighten the hexagon nut
(69) (width-across=13) for the screw-
fixing of the socket
- TP 1500 / 1500 RC: In the socket,
tighten the M5x12 (TX20) screw (70)
with a torque of 2 Nm
(72)(55)(68) (73)
Fig.25
(7)
Fig.21
Fig.22
(55)
(69) (70)
Fig.23 Fig.24