Fronius TransPocket 1500 - Page 72

72
- Fasten the X3 cable (blue) (72) and
the by-pass capacitors (73) onto the
copper bracket (55), using the 5x12 -
TX20 screw (68)
- Tighten the 5x12 - TX20 screw (68)
with a torque of 2 Nm
- Plug the 10-pole Molex plug (41) onto
board LCA15
- Plug the 2-pole Molex plug (40) onto
board LCA15
- Arrange the ribbon cable (42) above
the cable harness, as shown in Fig.17
- Plug the ribbon cable (42) to board
FPA15 (5)
Fitting the FPA15
board
(continued)
- Replace the setting dial (6)
Note! When thigthening the
fixing nut for the “Welding-
amperage setting dial“, hold the
dial (6) firmly
- Thigthen the fixing nut of the setting
dial (6) with the socket spanner (width-
across 7)
- Replace the cap to the “Welding-
amperage setting dial“ (6)
- Thigthen the round nut (66)
(72)(55)(68) (73)
Fig.14
Fig.17
(40) (41) (42)(5)
(6)
(66)
Fig.16
Fig.15