Fronius TransPocket 180 - Replacing the TP180 Fan

94
Remove the six spacers and screws
(5) from the faulty LC1800 PC board
(3)
Fit six spacers and screws (5) to the
new LC1800 PC board
Tightening torque = 2.1 Nm
Insert the LC1800 PC board (3)
Fit the leads (6) as shown and fit a ca-
ble tie
Replacing the
TP180
fan
Replacing the fan
Install the new fan (4)
- The arrow on the fan must point
backwards
- The fan leads must be on top and
facing the outside
(5)(3)
3
4
5
(6)
6
(4)
NOTE! Before installing the fan,
observe the direction of installa-
tion and cable routing
1