112
1) Interface to a 230 / 400 V, 50 Hz public grid
2) Detailed information concerning the duty cycle in single-phase operation is located
in chapter „Installation and commissioning“, section „single-phase operation“
Output voltage range according to standard characteristic (U
2
) in single-phase operation
MIG / MAG 14.5- 24 V
Rod electrode 20.4 - 27.2 V
Open circuit voltage (U
0
peak / U
0
r.m.s) 42 V
Protection class IP 23
Insulation class B
Overvoltage category III
Pollution level according to IEC60664 3
Safety symbols S, CE, CSA
Efficiency at 220 A and 25.0 V 87%
Dimensions l x w x h 687 x 276 x 445 mm
27.1 x 10.9 x 17.5 in.
Weight 30 kg
66.1 lb.
Max. shielding gas pressure 7 bar
101.49 psi
Wire feed speed 1 - 25 m/min
40 - 980 ipm.
Wire drive 4-roller drive
Wire diameter 0.8 - 1.6 mm
0.03 - 0.06 in.
Wirespool diameter max. 300 mm
max. 11.81 in.
Wirespool weight max. 20.0 kg
max. 44.1 lb.
To Next Page
Loading...
