Fronius TransSteel 2500c - Connecting a MIG;MAG Welding Torch

55
EN
TSt 2500c / TSt 2700c TSt 3500c
Secure the gas cylinder with a belt
Briefly open the gas cylinder valve to remove any dust or dirt
Check the seal on the pressure regulator
Connecting a
MIG/MAG welding
torch
1
NOTE! US devices (TSt 3500c only) are supplied with an adapter for the gas
hose:
- Seal male thread spacers on the gas solenoid valve using suitable means be-
fore screwing on the adapter.
- Test the adapter to ensure that it is gas-tight.
1
2
3
NOTE! When connecting the welding torch, check that
- all connections are connected properly
- all cables, leads and hosepacks are undamaged and correctly insulated.
1