Fronius TransSteel 3000c Pulse User Manual

Setup Menu 2nd Level
Limitations The following restrictions occur in relation to the Setup menu 2nd level:
Setup menu 2nd level cannot be selected:
- during welding
- if the "Gas test" function is active
- if the "Wire threading" function is active
- if the "Wire withdrawal" function is active
- if the "Gas purging" function is active
If level 2 of the Setup menu is selected, the following functions are not available, even in
robot mode:
- Welding start-up - the "Power source ready" signal will not be emitted for robot mode
- Gas test
- Wire inching
- Wire withdrawal
- Gas purging
Operation (Setup
Menu 2nd Level)
Accessing the 2nd level of the Setup menu:
MANUAL
STD SYNERGIC
PULSE SYNERGIC
1
Press the "Process" button to select the
"MIG/MAG standard synergic welding"
process
MANUAL
STD SYNERGIC
PULSE SYNERGIC
2T
4T
+
+
2
The control panel is now located in the
Setup menu of the "MIG/MAG standard
synergic welding" process - the last selec-
ted setup parameter is displayed.
3
Select the "2nd" setup parameter using the
left-hand selection dial
MANUAL
STD SYNERGIC
PULSE SYNERGIC
2T
4T
+
+
4
The control panel is now located in the
2nd level of the Setup menu of the
"MIG/MAG standard synergic welding"
process - the last selected setup para-
meter is displayed.
Adjusting parameters
1
Select the desired setup parameter using
the left-hand selection dial
Change the setup parameter value using
the right-hand selection dial
Exiting the Setup menu
MANUAL
STD SYNERGIC
PULSE SYNERGIC
2T
4T
+
+
1
A parameter is displayed in the first level
of the Setup menu.
107
EN-US

Fronius TransSteel 3000c Pulse Specifications

General

Brand	Fronius
Model	TransSteel 3000c Pulse
Category	Welding System
Language	English