Control Panel
General The functions are all arranged in a logical way on the control panel. The individual para-
meters required for welding can be
- Selected by means of buttons
- Changed using buttons or the selection dial
- Shown on the digital display during welding.
Due to the synergic function, all other parameters are also adjusted if a single parameter
is changed.
NOTE!
Because of software updates, certain functions may be available for your device
but not described in these Operating Instructions or vice versa.
In addition, individual figures may also differ slightly from the operating elements of your
device. However, the function of these operating elements is identical.
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
Serious personal injury and damage to property may result.
▶
Read and understand this document.
▶
Read and understand all the Operating Instructions for the system components,
especially the safety rules.
29
EN-US
To Next Page
Loading...
Need help?
General
