EasyManuals Logo

Fronius TransSteel 3000c Pulse User Manual

Fronius TransSteel 3000c Pulse
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #83 background imageLoading...
Page #83 background image
Igniting the arc When using a welding torch with a torch trigger and TIG Multi Connector plug
(with 2-step mode factory setting):
1 2 3 4
+
1
Position the gas nozzle at the ignition point so that there is a distance of approxim-
ately 2 to 3 mm (0.078 to 0.118 in.) between the tungsten electrode and the work-
piece
2
Gradually tilt the welding torch up until the tungsten electrode touches the workpiece
3
Pull back the torch trigger and hold it in this position
Shielding gas flows.
4
Raise the welding torch and tilt it into the normal position
The arc now ignites.
5
Carry out welding
Ending the weld-
ing process
1
Raise the TIG welding torch off the workpiece until the arc goes out.
Important! To protect the tungsten electrode, allow the shielding gas to flow after the
end of welding until the tungsten electrode has cooled down sufficiently.
2
Release the torch trigger
83
EN-US

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fronius TransSteel 3000c Pulse and is the answer not in the manual?

Fronius TransSteel 3000c Pulse Specifications

General IconGeneral
BrandFronius
ModelTransSteel 3000c Pulse
CategoryWelding System
LanguageEnglish

Related product manuals