Start-up
General Commissioning a power source is described by reference to a manual water-
cooled MIG/MAG application.
Information on
system compon-
ents
The steps and activities described below include references to various system
components, including:
-
trolley
-
upright console
-
cooling units
-
wire-feed units
-
interconnecting hosepacks
-
welding torches, etc.
For more detailed information about installing and connecting the system com-
ponents, please refer to the appropriate operating instructions.
Assembling the
system compon-
ents (overview)
WARNING!
Work that is carried out incorrectly can cause serious injury and damage.
▶
The following activities must only be carried out by trained and qualified per-
sonnel.
▶
All instructions in the section headed "Safety rules" must be observed.
The diagram below is intended to show you how to fit the individual system com-
ponents.
49
EN
To Next Page
Loading...
