Factory setting: OFF
AAG Gouging (Arc Air Gauging)
Arc air gouging with a carbon electrode, e.g., for joint preparation
Unit: -
Setting range: on / oFF
Factory setting: oFF
FAC Reset power source to factory settings
Press and hold down one of the "Parameter selection" buttons for 2 s to
restore the factory settings - when "PrG" appears on the digital display,
the power source has been reset.
IMPORTANT! When the power source is reset, all personal settings are
lost.
When the power source is reset, operating points that were saved using
the "Save" buttons are not deleted, but are retained in the memory. The
functions in the second level of the Setup menu (2nd) are also not de-
leted. Exception: Ignition time-out function parameter (ito).
2nd Second level of the set-up menu (see "Set-up menu - Level 2")
97
EN
To Next Page
Loading...
