Fronius TransTig 3000 Comfort - AC Setup 2 nd Menu Operations; Changing AC Setup 2 nd Parameters

107
EN
AC setup 2nd
General This setup is only available with MagicWave power sources.
Opening the AC
setup 2nd
Changing weld-
ing parameters
Open the AC setup
Select the 'AC setup 2nd' parameter
Press the adjusting dial
The AC setup 2nd parameters are shown:
The power source is now in AC setup 2nd.
1
2
3
Select the desired welding parameter by turning the adjusting dial:
To set the welding parameter, press the adjusting dial
The value of the selected welding parameter can now be changed:
1
2