Fronius TransTig 3000 Comfort - Rod Electrode Setup 2 nd Menu Operations; Changing Rod Electrode Setup 2 nd Parameters

130
Rod elec. setup 2nd (rod electrode setup 2nd)
Opening the rod
electrode setup
2nd
Changing weld-
ing parameters
Open the rod electrode setup
Select the 'rod electrode setup 2nd' parameter
Press the adjusting dial
The parameters for rod electrode setup 2nd are shown:
The power source is now in rod electrode setup 2nd
1
2
3
Select the desired welding parameter by turning the adjusting dial:
To set the welding parameter, press the adjusting dial
The value of the selected welding parameter can now be changed:
1
2