Fronius WF 15i - Adjust the Brake; General; Adjusting the Brake

Adjust the brake
General
NOTE!
Overrunning of the brake can result in damage to property.
▶
After releasing the torch trigger / wire threading button the wirespool must stop un-
reeling.
▶
If it continues unreeling, readjust the brake.
Adjusting the
brake
CAUTION!
Danger from welding current and accidental ignition of an arc.
This can result in severe personal injury and damage to property.
▶
Before starting work, disconnect the ground earth connection between the welding
system and the workpiece.
CAUTION!
Danger from emerging wire electrode.
This can result in severe personal injury and damage to property.
▶
Hold the welding torch with the end directed away from the face and body.
▶
Wear suitable protective goggles.
▶
Do not point the welding torch at people.
▶
Make sure that the wire electrode does not touch any conductive or earthed parts
(e.g. housing).
1
4
5
STOP
6
7
3
1
2
1
2
1
2
51
EN