Frontier ST1332 - SERVICE RECOMMENDATIONS; Maintenance Schedule; After Each Use Checklist

SERVICE RECOMMENDATIONS
24
MTF−051059L
SERVICE RECOMMENDATIONS
PROCEDURE
FIRST
2
HOUR
BEFORE
EACH
USE
OFTEN
EVERY
5
HOURS
EVERY
10
HOURS
EVERY
25
HOURS
BEGINNING
EACH
SEASON
BEFORE
STORAGE
S
N
Tighten all screws and nuts
√ √
√
N
O
W
Auger Drive Belt *
√ √
W
T
H
Adjust Traction Drive Belt 
√ √  √  √
R
O
W
Lubricate Auger Shaft
√ √ √
W
E
R
Lubricate Chute Rotation
Gear
√ √ √
E
N
G
Oil, Check
√ √
√
G
I
N
E
Oil, Change
√
√ √
* Adjust after 2 to 4 hours of use.
 Adjust after First 10 hours and then Every 25 hours of use.
The warranty on this snowthrower does not cover items that
have been subjected to operator abuse or negligence. To re-
ceive full value from the warranty, operator must maintain
snowthrower as instructed in this manual. The following Ser-
vice Recommendations is supplied to assist operator to
properly maintain snowthrower. This is a check list only. Ad-
justment referred to will be found in Adjustments/Repairs
section of this manual.
AFTER EACH USE
1. Check for any loose or damaged parts.
2. Tighten any loose fasteners.
3. Check and maintain the auger.
4. After each use, remove all snow and slush off the snow-
thrower to prevent freezing of auger or controls.
5. Check controls to make sure they are functioning proper-
ly.
6. If any parts are worn or damaged, replace immediately.