INSTALLATION (continued)
Optional Wedge Setup:
1. Hold the Optional Mounting Wedge at the predetermined
location. If possible, use a level to ensure the mount is
parallel with the ground.
a. Use a pencil to mark where the two screws
will go, indicated in the image below.
b. Once marked, you can set aside the
Optional Mounting Wedge until Step 4.
2. Prepare your power drill and drill into each of the 2 marked
locations on the wall, depending on your mounting surface:
a. If screwing into drywall or brick, it’s recommended
to use a 1/4” drill bit.
b. If screwing into wood, use a 1/8” drill bit.
Not sure which to use? Use the 1/4” drill bit.
3. Insert the included anchors into the screw holes if you used
a 1/4” drill bit. If you used the smaller drill bit, the anchors
will not be necessary.
4. Position the Optional Mounting Wedge so its 2 holes align
with the 2 screw holes.
5. Use your power drill to screw in the included screws,
fastening the Optional Mounting Wedge to the wall.
1
A
B
2
A
B
3
4
12
5
To Next Page
Loading...