12
7. Command Line
Enter Command
Use this section to test commands sent to a device to verify that it performs the action desired. Use the drop down list to
select examples of FrontRow command protocols.
Serial Port Configuration
COM Port The COM Port menu specifies the COM port number that the parameters on this page apply to; the CM900 has
2 COM Ports.
Baud Rate Specifies the data speed at which this device should communicate with the attached serial device; while 9600 and
19200 are typical for projectors, data speeds vary by manufacturer.
Stop Bits Specified by the manufacturer of the connected serial device, but is typically 1.
Parity Specified by the manufacturer but is typically None.
Set to input control mode (COM Port 2 only) Sets the second serial port to a mode where it accepts incoming serial
commands to control things like volume. Ref. Serial Commands in Appendix A.
To Next Page
Loading...