4-6
3. Snap the Power Shower into the frypot.-
DANGER
DO NOT operate the filter without the Power Shower in place unless unit is
configured with a rear flush option. Hot oil will spray out of the fryer and may cause
injury.
4. After all oil has drained from the pot, turn the
filter handle to ON to start the pump and
begin the filtering process. (For units
equipped with a rear-flush option, position
the control lever to either the Power Shower
or Rear Flush position.) There may be a slight
delay before the pump activates.
5. The oil moves through the filter, the frypot
and out the open frypot-drain during a five-
minute filtering process known as
“polishing”. Polishing cleans the oil and
washes small particles and sediment from the
frypot.
To Next Page
