LPD
The Line Printer Daemon (LPD) protocol is used to provide printer spooling and network
print server functionality for operating systems such as HP-UX, Linux
®
, and MAC OS X.
Note
For information on setting up print queues on your client system, refer to your client
system’s documentation.
Enabling LPD
To enable the LPD protocol:
1. In CentreWare Internet Services, click Properties > Connectivity > Port Settings.
2. Next to LPD, select the Enabled check box.
Note
Disabling LPD will affect clients printing to the printer over TCP/IP using the LPR printing
port.
Configuring LPD
To configure the LPD protocol:
1. In CentreWare Internet Services, click Properties > Connectivity > Protocols >
LPD.
2. Type an LPD Port Number or use the default port number of 515.
3. Enter the Connection Time-Out.
4. Enter the Maximum Number of Sessions.
5. If necessary, next to TCP-MSS Mode, select Enabled.
6. If TCP-MSS mode is enabled, type the IP addresses for Subnets 1, 2, and 3 under
IPv4.
7. Click Apply.
Note
TCP-MSS settings are common for LPD and Port 9100.
5-9 Xerox
®
Color C60/C70 Printer
System Administrator Guide
Network Configuration
To Next Page
Loading...
