3. Next to WSD Scan, select Enabled to enable the WSD scan service.
4. Click Apply.
Configuring WSD
To configure the WSD protocol:
1. In CentreWare Internet Services, click Properties > Connectivity > Protocols >
WSD.
2. Edit the following settings if required:
• Port Number. The default is 80.
• Data Receive Time-Out in seconds. The default is 30
• Notification Delivery Time-Out in seconds. The default is 8.
• Maximum TTL. The default is 1.
• Maximum Number of Subscribers. The default is 50.
3. Click Apply.
Xerox
®
Color C60/C70 Printer5-18
System Administrator Guide
Network Configuration
To Next Page
Loading...
