4 Fax
206
Fax
4
A file received in the folder can automatically be printed depending on the folder settings. For information on the folder
settings, refer to "Configuring/Starting Job Flow" (P.328).
Depending on the report print settings, a Folder Report may not be printed even after a file is received in a folder. For
information on the Folder Report setting, refer to "5 Tools" > "Common Service Settings" > "Reports" > "Folder Report" in the
Administrator Guide.
For information on how to print files received in a folder, refer to "Printing Files in a Folder" (P.326).
Sending to Folder (F Code Method)
1
Select [F Code]
2 Select [On].
3 Select the [F Code] box, and enter an F code using the displayed keyboard or the numeric
keypad.
Note •You can enter up to 20 digits for the F code.
4 If necessary, select the [Password] box, and enter a password using the displayed keyboard
or the numeric keypad.
Note •You can enter up to 20 digits for the password.
Off
The F code transmission is not used.
On
The F code transmission is used. Enter the F Code.
F Code
Select the [F Code] box, and enter the F code using the displayed keyboard or the numeric
keypad.
Note •You can enter up to 20 digits for the F Code.
Password
Select the [Password] box, and enter the password using the displayed keyboard or the
numeric keypad. If a password is not set, leave this box blank.
Note •You can enter up to 20 digits for the password.
Keyboard
Enter the F code or the password using the displayed keyboard.
For information on how to enter texts, refer to "Entering Text" (P.79).
5 Specify a destination, and then press the <Start> button.
To Next Page
Loading...
