FujiFilm FRONTIER 375 - Page 87

87
FMPC
6
Before the pump starts discharging, disconnect
the PS-R replenisher nozzle and insert it into the
measuring cylinder.
• The replenisher pump starts discharging after
the alarm beeps for 10 seconds.
• The alarm beeps when discharging is
completed.
7
Insert the PS-R replenisher nozzle into the PS
sub-tank.
8
Place the measuring cylinder on a level surface,
then read and record the output.
9
Pour the replenisher solution from the measuring
cylinder into the waste recovery tank.
10
Select the “Measured value” box for “PS-R” and
enter the recorded output value using numeric
keys.
The machine automatically measures and adjusts
the pump outputs for P1-R, P2-RA and P2-RB.
11
Click [OK].
• Operation returns to the “4 Setup and
Maintenance” screen.
12
Select the “END [1]” on the menu bar.
• Control returns to the “Main Menu” screen.
13
Reinstall the sub-tank cover.
14
Clean the measuring cylinder.
PS-R Replenisher Nozzle
Measuring Cylinder
EZ747
distributed by www.minilablaser.com