Color monitor 21P3
A26361-K618-Z100-2-5E19 English - 17
Electrical data
Video: Analog, positive, 0.7 V
pp
,75Ohm
Synchronization: Separate Sync. TTL
Horizontal frequency: 30 kHz .... 115.6 kHz (multi-scanning)
Refresh rate: 50 Hz .... 160 Hz
Maximum pixel rate: 260 MHz
Power supply (switches over automatically): 100 V -120 V (±10 %)
200V-240V(±10 %)
50Hz-60Hz
Power consumption:
(see power management):
< 130 W (ON, Normal mode)
< 8 W (Standby mode)
< 8 W (Suspend mode)
< 3 W (OFF mode)
CRT
Color characteristics (color coordinates): Red x = 0.625 y = 0.340
Green x = 0.285 y = 0.605
Blue x = 0.150 y = 0.065
White x = 0.283 y = 0.297
Color temperature (color calibration 1): 9300
Gamma value: 2,66
Environmental conditions
Environment class 3K2, IEC 721
Rated range of operation: 15 °C .... 35 °C
Humidity: 20 % .... 85 %
Limit range of operation: 5 °C .... 40 °C
Humidity: 20 % .... 85 %
Condensation must be avoided.
VESA-DDC-compatible VGA interface
Your monitor is equipped with a VESA-DDC-compatible VGA interface. VESA-DDC (Video
Electronics Standard Association, Display Data Channel) is used as the communications interface
between the monitor and the PC. If your PC is equipped with a VESA-DDC-compatible VGA
interface, it can automatically read the data for ensuring optimum operation from your monitor and
select the appropriate settings.
i
If the monitor 21P3 is not yet displayed in the list of monitors, you can select one of the
following monitors instead:
Fujitsu Siemens, Siemens or
Siemens Nixdorf
MCM 213V, MCM 2110, MCM 212V, MCM 2108 NTD,
MCM 2106 NTD, MCM 2103 ND
Hitachi CM812, CM2198M, CM2112
Philips 201B
MIRO C2193
To Next Page
Loading...
Need help?
General
