Getting started
Connecting the machine to the mains
Mainsadapt er,
2
1
► Connect the mains cable to the machine (1).
► Plug the mains plug into a three-pin socket ( 2).
Switching on for the first time: installing the software
Installing,Software,Installing,
If the device is integrated into a network, the use r and server details as well as the
network protocol are required during the software installation.
When you switch on the device for the first time, the supplied software is insta lled and configured.
Plan a reasonable amount of time fo r this, as this process must no t be interrup ted.
Once the installation has been started the device must not be switched
off, unless the installation has bee n completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents
of the hard disk must be completely restored.
10 - English 10600985329, edition 1
To Next Page
Loading...
Need help?
General
