Supplement to the operating instructions
A-2
Supplement to the operating instructions
Guidelines and Environmental Protection
An important characteristic of our products, alongside quality and performance, is
environmental friendliness.
(I) Protection of resources with energy-saving functions
Our units generally have energy-saving modes.
(II) Device safety
The units meet the requirements of the low voltage directive 73/23/EEC including
the amendment 93/68/EEC, certified in accordance with EN 60950, and the
directive on electromagnetic compatibility 89/336/EEC including the amendment
93/68/EEC.
(III) Guarantee of electromagnetic compatibility
All data and signal cables must be provided with sufficient shielding. The minimum
requirement is a Category 5 shielded cable for 10/100 Ethernet, or Category 5e for
Gigabit Ethernet. As described in the operating instructions, all of the housing parts
must be installed.
(IV) Requirements for work with monitors
Our units meet the requirements set for work with monitors in accordance with the
EU screen directive 90/270/EEC for the purposes of the EU directive 89/391/EEC.
(V) Lasers
If your system has an optical drive such as a CD-ROM, CD-RW, DVD or combined
drive, the following applies:
With closed PC housings, the optical drives used correspond to laser class 1 in
accordance with IEC 60825-1. These contain light-emitting diodes (LED) which
under some circumstances may generate a stronger light beam than laser class 1.
A direct glance into this beam, even with protective eyewear, is dangerous and may
lead to injury. Therefore, no
parts of the optical drive housing are to be removed.
(VI) Operating instructions
The documentation delivered with the unit has been printed solely on chlorine-free
paper.
The documents referred to above may be viewed at the manufacturer if required.
bostext
To Next Page
Loading...
Need help?
General